Accessories

9 product

Door switch

Door switch for monitoring the position of enclosure doors and triggering further actions. Depending on requirements, this can, for example, switch on lighting (NC) when the enclosure door is opened or activate ventilation (NO) when the door is closed. The design with change-over contact (CO) enables use as a contact breaker and/or normally open contact.

SFP 095

Stegofix Plus device holder

The STEGOFIX PLUS device holder is a flexible alternative to the 35 mm DIN rail. It enables quick and easy installation of small or additional devices that are designed for fixing on DIN rails. The STEGOFIX PLUS is suitable for devices with a clip width of max. 66 mm and offers the right mounting method for almost every application with its versions - screw fixing in 25 mm increments, high-performance adhesive tape and rubberised neodymium magnets.

DA 284

Pressure compensation device

Passive pressure compensation element for enclosures and enclosures. Levelling temperature-induced pressure differences between the inside and outside of the enclosure. Air humidity escapes through a waterproof membrane. The formation of condensate is prevented.

DD 084

Drainage device

Drainage device for draining condensate from casings. In compliance with protection type IP66. No splash water penetrates as a water flow-through membrane drains the enclosure by capillary action.

SD 035

Electrical socket

Electrical socket for installation on 35 mm DIN rail. Quick, screwless electrical connection using pressure clamps. Designs with and without fuse are available.

DAK 284

Ventilation cable gland

Passive pressure compensation element for the safe insertion of cables into a casing. Levelling temperature-induced pressure differences between the inside and outside of the enclosure. Air humidity escapes through a waterproof filter. The formation of condensate is prevented.

DA 084

Pressure compensation device

In tightly sealed enclosures and casings, internal or external heat influences cause temperature fluctuations due to different pressure ratios. Pressure compensation devices compensate for pressure changes while maintaining a high protection type and preventing the ingress of dust and air humidity. The pressure compensation devices are suitable for use in enclosures and casings in accordance with DIN EN 62208.

DA 284

Snap-in pressure compensation element

DA 284

Accessories

Door switch

Stegofix Plus device holder

Pressure compensation device

Drainage device

Electrical socket

Ventilation cable gland

Pressure compensation device

Snap-in pressure compensation element

Pressure compensation device

Calculation tool

Innovation and Safety

Talk to an expert

Your direct contact

Stego Worldwide